Save on Barnes 4WD products at Zona Indonesia. Hurry! Limited time offers. Offers valid only while supplies last.
JEEP TJ DANA 44 REAR AXLE SWAP KIT
We designed our Jeep TJ Wagoneer Dana 44 swap kit to make it easy for you to put a Dana 44 in the rear of your Jeep TJ, or LJ. This kit is designed to work with a Dana 44 rear axle out of a 1980-1991 Jeep Wagoneer narrow track (~60" WMS-WMS) or a fac...
DANA 60 BRONZE UPPER KINGPIN BUSHINGS
Our Dana 60 bronze upper kingpin bushings have been engineered to take the place of the factory plastic bushings that can fail under heavy use. If you are hard on your rig, these are a great upgrade for added reliability. Only to be used with afterma...
FRAME SHOCK TOWER PAIR
Barnes 4WD Frame shock towers are great way to get your Air shocks, Coilovers or ORI struts mounted to your frame. These shock towers are made from ¼" steel, sure we could have made them out of 3/16" and saved some money but we did not feel that wou...
7/8 INCH HEIM STEERING KIT NO TUBING
This is our universal heavy duty crossover steering kit with our super strong 7/8 inch heat treated chromoly heims. Kit Includes: 1 Right Hand and One Left Hand 7/8-14 x 7/8 Heim 1 Right Hand and One Left Hand 7/8-14 x 3/4 Heim 4 Hex Weld-in threaded...
PRO SERIES JEEP JK FRONT AXLE TRUSS (Dana 44)
The Barnes 4WD Pro Series Jeep JK Dana 44 and Dana 30 Front Axle Trusses are made from a combination of 1/4" and 3/16" Ultra 100 steel to keep them light but incredibly strong. This truss is made to be a precise fit to the Jeep JK Front Dana 44 Rubic...
PRO-SERIES GM DANA 60 FRONT AXLE TRUSS
The Barnes 4WD Pro Series GM Dana 60 Front Axle Truss is a full width low profile truss made from a combination of 1/4" and 3/16" Ultra 100 steel to keep it light but incredibly strong. These trusses reach all the way to the steering knuckles and are...
TJ LJ REAR TAIL PLATE BUMPER
The TJ, LJ rear Tail Plate Bumper provides maximum departure angle, two recovery points and adds rigidity to the back of your frame. They are fabricated from 3/16" steel, the clevis mounts are ¾" thick and accept a 3/4" D-rings. The Barnes 4WD Tail ...
Browse Our Catalog